|

Candy Cane Bauble Knitting Pattern (Free)

THIS ARTICLE CONTAINS AFFILIATE LINKS THAT SUPPORT HANDY LITTLE ME CONTENT AND FREE PATTERNS.

This candy cane bauble knitting pattern adds a little red-and-white swirl to your Christmas tree.

The cover is knitted flat on straight needles, using alternating stripes and simple shaping to create the sloping design.

Once the knitting is finished, you’ll sew it into a tube, slip it over your bauble, and gather both ends.

A gentle twist of the finished cover helps the stripes settle into their candy cane shape.

Scroll down for the free knitting pattern, followed by the printable how-to card.

Christmas bauble cover knitted in red and white stripes

A Christmas Twist On My Swirl Tea Cozy

If you’ve made my ice cream swirl tea cozy, you may recognize the shaping used in this little ornament.

The bauble cover uses a similar combination of stripes, increases, and decreases to create its swirl.

You could also knit the tea cozy in red and white for a Christmas version to bring out with your festive mugs and teapot.

Before You Get Started

  • Skill level: Advanced beginner.
  • Construction: Knitted flat in one piece, then seamed and gathered around a bauble.
  • Techniques: Knit, purl, simple increases and decreases, seaming, and gathering.
  • Colors: Six-row stripes in off-white and red.

The cover is worked sideways: the 20 cast-on stitches run from the bottom to the top of the cover, while the repeated rows build the fabric that wraps around the bauble.

The shaping creates a slanted piece rather than a perfectly square rectangle.

Keep 20 stitches on the needle throughout; each shaping row decreases one stitch at the beginning and adds one near the end.

Tools And Materials Needed

Yarn

  • Yarn A: Approximately 20g / 40 meters / 44 yards of white or off-white DK yarn.
  • Yarn B: Approximately 20g / 40 meters / 44 yards of red DK yarn.
  • Yarn weight: Light/category 3 / DK.
  • I used DROPS Karisma in 18 Red and 01 Off White.

The lengths above are calculated for DROPS Karisma, which has approximately 100 meters per 50g ball.

If you substitute another yarn, check its length and allow extra for seaming and gathering.

Needles

Notions

  • Tape measure.
  • Darning or tapestry needle.
  • Scissors.
  • A bauble measuring approximately 9.75 inches / 25 cm around its widest part.
  • Ribbon or hanging cord, if needed.
Candy cane Christmas bauble

Size And Fit

The knitted piece measures approximately:

  • Width around the bauble: 9 inches / 23 cm.
  • Height from bottom to top: 3.5 inches / 9 cm.

These are the intended dimensions when the piece is positioned for assembly. Because the fabric slopes, avoid measuring along a diagonal.

The cover fits a bauble with a circumference of approximately 9.75 inches / 25 cm, measured around its widest part.

The knitted fabric is slightly narrower than the bauble’s circumference so it can stretch around it.

Check the fit before sewing: the cast-on and cast-off edges should meet comfortably around the bauble without large gaps or excessive stretching.

These instructions are written for the size shown.

Changing the cast-on stitch count changes the cover’s height; changing the number of stripe repeats changes the distance around the bauble.

A different bauble size will need a fit check and may require both adjustments.

Gauge

DROPS Karisma’s recommended stocking-stitch gauge is 21 stitches and 28 rows = 4 inches / 10 cm, using 4 mm (US 6) needles.

This is a yarn reference, rather than a measured gauge for the striped swirl pattern.

The alternating stitch texture and shaping will affect the finished measurements.

Use the intended dimensions and your bauble as the main guide.

Check the height after working a few stripes, then check the wraparound width as the piece grows.

If the fabric is too tight or too loose, try a different needle size and check again.

Abbreviations

  • K: Knit.
  • K2tog: Knit the next two stitches together; decreases one stitch.
  • P: Purl.
  • P2tog: Purl the next two stitches together; decreases one stitch.
  • M1L: With the left needle, lift the strand between the stitches from front to back, then knit into the back of the loop.
  • M1PL: With the left needle, lift the strand between the stitches from front to back, then purl into the back of the loop.
  • Rep: Repeat.
  • St(s): Stitch(es).
Knitted Christmas bauble covers

Candy Cane Bauble Knitting Pattern

Make one piece.

  • Yarn A: White or off-white.
  • Yarn B: Red.

Cast on 20 stitches using Yarn A.

White Stripe

  • Row 1: Knit.
  • Row 2: P2tog, purl to the last stitch, M1PL, K1.
  • Row 3: Knit.
  • Row 4: P2tog, purl to the last stitch, M1PL, K1.
  • Row 5: Knit.
  • Row 6: P2tog, purl to the last stitch, M1PL, K1.

Red Stripe

Change to Yarn B.

  • Row 7: Purl.
  • Row 8: K2tog, knit to the last stitch, M1L, K1.
  • Row 9: Purl.
  • Row 10: K2tog, knit to the last stitch, M1L, K1.
  • Row 11: Purl.
  • Row 12: K2tog, knit to the last stitch, M1L, K1.

You should still have 20 stitches after every row.

Repeat Rows 1–12 a further six times, changing back to Yarn A for Row 1 of each repeat.

You will have worked 84 rows, making 14 stripes altogether: seven white and seven red.

Cast off without pulling the edge tight.

Leave a yarn tail for sewing.

Candy cane knitted bauble cover laid flat

How To Assemble Your Knitted Christmas Bauble

1. Sew The Seam

Lay the knitted piece with your chosen outward-facing side towards you.

Bring the cast-on and cast-off edges together to form a tube.

These are the short ends of the strip; the long row edges will form the top and bottom openings.

Using a tapestry needle and matching yarn, sew the cast-on and cast-off edges together with a neat, flexible seam.

Align the edges stitch for stitch and avoid pulling the seam tight.

2. Gather The Bottom

Thread a separate length of matching yarn through the row-edge stitches around one open end of the tube.

Pull gently to gather the opening.

Secure the yarn and weave in the end.

3. Insert The Bauble

Slide the bauble into the knitted cover with its hanging cap at the open end.

Ease the fabric around the bauble and spread the stripes evenly.

4. Gather The Top

Thread a length of matching yarn through the row-edge stitches around the remaining opening.

Draw the opening together around the bauble’s hanging cap, keeping the hanging loop accessible.

Secure the gathering yarn.

5. Adjust The Swirl

Once both ends have been cinched, the cover may need a little gentle twisting to help the stripes settle into their swirl.

Hold the bauble steady and ease the fabric around it, slightly rotating the top of the cover relative to the bottom until the stripes look softly twisted.

Adjust the fabric rather than turning the bauble’s hanging cap.

Smooth the stripes and distribute the gathers evenly, then weave in any remaining ends.

Add a ribbon or hanging cord if needed, and your candy cane bauble is ready for the tree!

Candy cane swirl knitted Christmas bauble

Free Printable Pattern

You can find the free instructions in the how-to card below.

Use the print option to keep a copy beside you while you knit.

The card includes the materials, row-by-row knitting instructions, and assembly steps, including how to adjust the finished swirl.

Yield: Candy Cane Bauble Cover

Candy Cane Bauble Knitting Pattern

Christmas bauble cover knitted in red and white stripes
No Ratings

Knit a festive candy cane bauble cover with red-and-white stripes and a softly twisted swirl.

This free pattern is worked flat on straight needles, then seamed and gathered around a bauble—a lovely little project for advanced beginners.

Prep Time 10 minutes
Active Time 2 hours
Additional Time 15 minutes
Total Time 2 hours 25 minutes
Difficulty Advanced Beginner
Estimated Cost $10

Materials

  • Yarn A: Approximately 20g / 40 metres / 44 yards of white or off-white DK yarn.
  • Yarn B: Approximately 20g / 40 metres / 44 yards of red DK yarn.
  • Yarn weight: Light / category 3 / DK.
  • I used DROPS Karisma in 18 Red and 01 Off White.
  • The lengths above are calculated for DROPS Karisma, which has approximately 100 metres per 50g ball. If you substitute another yarn, check its length and allow extra for seaming and gathering.

Tools

  • Pair of 4 mm (US 6) knitting needles
  • Tape measure
  • Darning or tapestry needle.
  • Scissors.
  • A bauble measuring approximately 9.75 inches / 25 cm around its widest part.
  • Ribbon or hanging cord, if needed.

Instructions

Candy Cane Bauble Knitting Pattern

Make one piece.

Yarn A: White or off white.

Yarn B: Red.

Cast on 20 stitches using Yarn A.

White Stripe

  • Row 1: Knit.
  • Row 2: P2tog, purl to the last stitch, M1PL, K1.
  • Row 3: Knit.
  • Row 4: P2tog, purl to the last stitch, M1PL, K1.
  • Row 5: Knit.
  • Row 6: P2tog, purl to the last stitch, M1PL, K1.

Red Stripe

Change to Yarn B.

  • Row 7: Purl.
  • Row 8: K2tog, knit to the last stitch, M1L, K1.
  • Row 9: Purl.
  • Row 10: K2tog, knit to the last stitch, M1L, K1.
  • Row 11: Purl.
  • Row 12: K2tog, knit to the last stitch, M1L, K1.

You should still have 20 stitches after every row.

Repeat Rows 1–12 a further six times, changing back to Yarn A for Row 1 of each repeat.

You will have worked 84 rows, making 14 stripes altogether: seven white and seven red.

Cast off without pulling the edge tight. Leave a yarn tail for sewing.

How To Assemble Your Knitted Christmas Bauble

1. Sew The Seam

Lay the knitted piece with your chosen outward-facing side towards you.

Bring the cast-on and cast-off edges together to form a tube. These are the short ends of the strip; the long row edges will form the top and bottom openings.

Using a tapestry needle and matching yarn, sew the cast-on and cast-off edges together with a neat, flexible seam. Align the edges stitch for stitch and avoid pulling the seam tight.

2. Gather The Bottom

Thread a separate length of matching yarn through the row-edge stitches around one open end of the tube.

Pull gently to gather the opening. Secure the yarn and weave in the end.

3. Insert The Bauble

Slide the bauble into the knitted cover with its hanging cap at the open end.

Ease the fabric around the bauble and spread the stripes evenly.

4. Gather The Top

Thread a length of matching yarn through the row-edge stitches around the remaining opening.

Draw the opening together around the bauble’s hanging cap, keeping the hanging loop accessible.

Secure the gathering yarn.

5. Adjust The Swirl

Once both ends have been cinched, the cover may need a little gentle twisting to help the stripes settle into their swirl.

Hold the bauble steady and ease the fabric around it, slightly rotating the top of the cover relative to the bottom until the stripes look softly twisted. Adjust the fabric rather than turning the bauble’s hanging cap.

Smooth the stripes and distribute the gathers evenly, then weave in any remaining ends.

Add a ribbon or hanging cord if needed, and your candy cane bauble is ready for the tree!

Notes

Size And Fit

The knitted piece measures approximately:

  • Width around the bauble: 9 inches / 23 cm.
  • Height from bottom to top: 3.5 inches / 9 cm.

These are the intended dimensions when the piece is positioned for assembly. Because the fabric slopes, avoid measuring along a diagonal.

The cover fits a bauble with a circumference of approximately 9.75 inches / 25 cm, measured around its widest part.

The knitted fabric is slightly narrower than the bauble’s circumference so it can stretch around it. Check the fit before sewing: the cast-on and cast-off edges should meet comfortably around the bauble without large gaps or excessive stretching.

These instructions are written for the size shown. Changing the cast-on stitch count changes the cover’s height; changing the number of stripe repeats changes the distance around the bauble. A different bauble size will need a fit check and may require both adjustments.

Gauge

DROPS Karisma’s recommended stocking-stitch gauge is 21 stitches and 28 rows = 4 inches / 10 cm, using 4 mm (US 6) needles.

This is a yarn reference, rather than a measured gauge for the striped swirl pattern. The alternating stitch texture and shaping will affect the finished measurements.

Use the intended dimensions and your bauble as the main guide. Check the height after working a few stripes, then check the wraparound width as the piece grows. If the fabric is too tight or too loose, try a different needle size and check again.

Abbreviations

  • K: Knit.
  • K2tog: Knit the next two stitches together; decreases one stitch.
  • P: Purl.
  • P2tog: Purl the next two stitches together; decreases one stitch.
  • M1L: With the left needle, lift the strand between the stitches from front to back, then knit into the back of the loop.
  • M1PL: With the left needle, lift the strand between the stitches from front to back, then purl into the back of the loop.
  • Rep: Repeat.
  • St(s): Stitch(es).

Did you make this?

Please leave a comment on the blog or share a photo on Pinterest

Share Your Work With Us

Have you made your own candy cane bauble? I’d love to see how it turned out!

Share a photo on Instagram and tag @handylittleme, or post your finished decorations in the Handy Little Me Community Facebook group.

Whether you’ve used classic red and white or chosen colors to match your Christmas tree, it’s always lovely to see your take on the pattern.

Candy Cane Bauble Knitting Pattern

Leave a Reply

Your email address will not be published. Required fields are marked *